03 Envoy

Does anyone know if the 03 Envoy is the same as the 02 as far as Security/Start installations are concerned? I'm getting the O.E. Security light coming on after remote starting. Even after the key is put in and turned on and the brake is pressed, the security light still stays on. I have to shut it down and re-start it manually for the light to go out. What am I not doing?

Try to figure out the behavior of the security light, more information will help us diagnose the problem. Determine when the light comes on specifically.  Start the car with the key and compare what the light does then compared towhen you remote start it.   Also it is helpful to know how consistently the security light turns on.  Then post the results.

Hey Jeff,  if your out there... O.K.  To start with, I'm using Code-Alarm GUIDES so bare with me... I was trying to use a Audiovox  AS-GMDTIDL GM data interface but I could'nt get it to work. This is my first Envoy   (I usually only install at Ford and Chrysler Dealerships) and I am confident that I located the correct module (drivers side, lower left of steering column, 3 conn.?) But, I still could be wrong! So, I just 5-wired it in the doors. Then I used a Audiovox AS-GM4 to bypass the PASSLOCK II, there are however, 3 yellow wires of the same gauge in that area. It may be possible I cut the wrong wire. After I cut the wire, it read 6K and reversing the leads I got 6.4K, making me think this was the correct wire.

What are ya thinkin?

Jeff,  I thought the same thing and tried it last night, everythings works fine now! No refunds necessary!!