valet 561r remote start problems

iv installed about 50 or so radios in my life, but never a remote start or keyless entry. maybe this is to complicated for me to do? i would buy a book if i could find one that would help me in this area. i am tring to install a valet 561R remote start in to my 1990 chevy astro van. im having problems figuring out what wire goes were? if someone can connect the dots it would be great! sorry about the size of the diagrams its the biggest 12volt  would allow.

thanks THEGOOSE 

THANKS ALOT JWORM i will give that a shot in the morning!

thanks again for your time THEGOOSE

i bought 2 of these and planned on installing one on my wifes 1995 chevy s10 blazer. if i get this one hooked up right im going to hook up that one . do you know if it is the same instructions for that car?

thanks for your time THEGOOSE

yes i read it front to back but im a nubie to this and comprehending it is a bit of a problem to me. i think these will be the last ones i install. i think its out of my skill level. i didnt know what [RED / black (-) 200ma channel 2 output] realy ment or where it went but turns out it didnt apply to my van.      but i got it to remote start im trying to get it to lock/unlock now im not getting a pulse to the test light from the blue or green wires so im rereading to find out what to do.

thanks thegoose

i cant get the doors to lock or unlock at all with the fob so i guess im going to give up and return them.

THANKS THEGOOSE

can't tell in your diagram for sure. valert 561 looks same as avital 4000. if so, then for you power locks to work, you have to use two relay or a 451M since the unit only outputs a negative trigger

YEA THAT IS WERE I HAD THEM CONNECTED BUT THE PROBLEM WAS THE KEYLESS ENTRY WASNT PUTTING A PULSE OUT.

THANKS THEGOOSE