1996 dodge ram 2500
Topic Closed)
Members
Search
Register
Login
Posted: December 27, 2002 at 6:47 PM / IP Logged
Posted: December 27, 2002 at 11:55 PM / IP Logged
Well, did you hook up starter kill with the remote starter? How did you hook up the starter kill relay?
 Normally Closed Starter Kill Relay |
| The basic starter kill relay diagram shown below, breaks continuity of the lead from the ignition switch to the starter motor (or in some cases i.e.; Ford, to another relay), when the alarm is armed and the ignition is turned on. This is the most commonly used application for disabling the starter. Click here for another starter kill diagram. |
| Normerly Open Starter Kill |
| This normally open starter kill relay application below relies on a ground from the alarm when disarmed and 12 volts (+) from the ignition to enable the driver to start the vehicle. * Note: most alarms with this feature will not provide this grounded output when power ,12 volts (+), to the alarm is not present, even if the alarm is grounded. |
Sorry, you can NOT post a reply.
This topic is closed.
Printable version
| You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
| Search the12volt.com |
Follow the12volt.com 
Friday, June 7, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved • Privacy Policy & Use of Cookies
Friday, June 7, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved • Privacy Policy & Use of Cookies
Disclaimer:
*All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.
