passlock 2,wont start with key?

k,1998 seirra,installed the dei auto module and works great with the remote start.problem is the truck will not start with the key now.it wont even turn over.all the dash lights come on but the starter will not turn over.security light only stays on for a brief time then goes out like normal.its almost like the kill relay is still on.i bypass the relay and still nothing.

is this a passlock problem,remote  start works great.with the key it wont even engage the starter.is this long tamper problem?

Yes in long tamper mode, the engine will turn over, start running for about 2.5 seconds then stall out.  Then the security light on the dash will be flashing rapidly.  Best bet is disconnect the starter kill completely put the starter wire back together and try to start with key.  If truck runs then the starterkill is wired improperly.  Here's how should be wired (don't know if it would be the same if the relay has spike suppression)

85 - Ground when armed of alarm

86 - +12volt ignition

87a - Key side of starter wire

30 - motor side of starter wire.