AutoPage alarm

Home / the12volt's Install Bay / Car Security and Convenience / AutoPage alarm (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

mill1978

Member - Posts: 8

Joined: July 13, 2006

Location: United States

Posted: July 15, 2006 at 3:49 PM / IP Logged

I'm goin to install a autopage alarm on my 300m any pointers

josh1979

Silver - Posts: 320

Joined: July 03, 2006

Location: United States

Posted: July 15, 2006 at 7:54 PM / IP Logged

what year?

bring back the rotary phone so i dont have to press 1 to proceed in english

mill1978

Member - Posts: 8

Joined: July 13, 2006

Location: United States

Posted: July 15, 2006 at 9:33 PM / IP Logged

2002 300m Special

josh1979

Silver - Posts: 320

Joined: July 03, 2006

Location: United States

Posted: July 15, 2006 at 9:38 PM / IP Logged

all the pointers you should neew are right here

12volts	pink/black or red	+	ignition harness
Starter	yellow	+	ignition harness
Second Starter
Ignition	dk. blue/white	+	ignition harness
Second Ignition	GREEN/ red	+	ignition harness
Third Ignition
Accessory	BLACK/ orange	+	ignition harness
Second Accessory	BLACK/ white	+	ignition harness
Keysense	lt. blue	-	ignition harness
Power Lock	WHITE/ green		back of fusebox
Notes: Locks are positive trigger through resistors. Use 2.7K (2700) ohms for lock and 620 ohms for unlock. MUST use relays. Can also use Directed 457C or 456L interface modules.
Power Unlock	same wire
Lock Motor	orange		BCM
Notes: BCM is located on the left side of dash with junction block
Unlock Motor	dk. blue		BCM
Notes: BCM is located on the left side of dash with junction block
Parking Lights+	BLACK / YELLOW	+	driver kick panel
Parking Lights-	yellow		headlight switch
Notes: Use a 110 ohm resistor to ground (-) for parking lights and a 220 ohm resistor to ground (-) will do both headlights and parking lights.
Hazards
Turn Signal(L)
Turn Signal(R)
Reverse Light
Door Trigger	tan and tan/red	-	BCM
Notes: BCM is located on the left side of dash with junction block
Dome Supervision	yellow	-	rear of fuse box, brown plug
Trunk/Hatch Pin	tan/black	-	drivers kick panel
Hood Pin
Trunk/Hatch Release	BLACK/ white	+	at release switch
Power Sliding Door
Factory Alarm Arm	lt. GREEN/ orange		drivers kick panel
Notes: Arm is positive trigger thru a 1.87K ohm resistor, this will also lock the doors. Disarm is positive trigger thru a 680 ohm resistor, if use double pulse this will also unlock the doors. Must use relays. Can also use Directed 457C or 456L interface modules.
Factory Alarm Disarm	same wire
Disarm No Unlock
Tachometer			one of the coils
Notes: This vehicle has an ignition coil for each cylinder. For tach use a tan/stripe wire at any one of the coils.
Wait to start
Brake Wire	WHITE/ tan	+	at brake switch
Parking Brake
Horn Trigger	BLACK/ red	-	steering column
Memory Seat 1
Memory Seat 2
Memory Seat 3

Interface Module:	Category: Immobilizer Bypass	Required: Yes	Type: Sentry Key
Part #: 555CW
Alternate Part1 #: 556UW
Alternate Part2 #: DesignTech 20402
Alternate Part3 #: DesignTech 29402
Notes: Only vehicles with gray keys have the immobilizer.
Interface Module:	Category: Door Lock Interface	Required: Yes	Type: Data Bus
Part #: 457CW
Alternate Part1 #: 456LW

bring back the rotary phone so i dont have to press 1 to proceed in english

mill1978

Member - Posts: 8

Joined: July 13, 2006

Location: United States

Posted: July 16, 2006 at 6:21 AM / IP Logged

This will b easier than my 96 deville

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

AutoPage alarm

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.