the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2007 mini cooper keyless upgrade


Post ReplyPost New Topic
< Prev Topic Next Topic >
customcarelectr 
Member - Posts: 43
Member spacespace
Joined: February 05, 2004
Location: United States
Posted: March 22, 2007 at 9:55 AM / IP Logged  

2007 mini cooper.

customer wants to upgrade keyless to alarm (727t) as well as prox sensor.

anyone done one of these? anything to watch for any reccomends on prox location?

Please someone post the complete schematic for 2007 mini

thanks!!!

profuse007 
Gold - Posts: 2,015
Gold spacespace
Joined: October 20, 2002
Location: Texas, United States
Posted: March 22, 2007 at 11:03 AM / IP Logged  
2007 MINI COOPER 2DR HATCHBACK or CONV   
Security          
     WIRE          COLOR          POLARITY          LOCATION     
     Battery          RED          (+)          IGNITION SWITCH HARNESS     
     Ignition 1          GREEN          (+)          IGNITION SWITCH HARNESS     
     Starter 1          BLACK/ BLUE          (+)          IGNITION SWITCH HARNESS     
     All Door Trigger
YOU MUST DIODE ISOLATE BOTH TRIGGERS TO MONITOR ALL DOORS.      
     LF Latch          BROWN / GRAY / YELLOW DOTS          (-)          IN HARNESS IN DRIVERS KICKPANEL     
     RF Latch          BROWN / GRAY / YELLOW DOTS          (-)          IN HARNESS IN PASSENGER KICKPANEL     
     Trunk Trigger          GRAY/BROWN          (-)          IN PASSENGERS DOOR SILL HARNESS     
     Hood Trigger          GREEN/ VIOLET          (-)          AT PIN SWITCH UNDER HOOD     
     Parking Lights          BLACK          (-)          AT BCM MODULE IN PASSENGER KICKPANEL     
     Convenience          
     WIRE          COLOR          POLARITY          LOCATION     
     Please select another category
     Remote Start          
     WIRE          COLOR          POLARITY          LOCATION     
     Battery          RED          (+)          IGNITION SWITCH HARNESS     
     Ignition 1          GREEN          (+)          IGNITION SWITCH HARNESS     
     Ignition 2          VIOLET/BLACK          (+)          IGNITION SWITCH HARNESS     
     Starter 1          BLACK/ BLUE          (+)          IGNITION SWITCH HARNESS     
     Parking Lights          BLACK          (-)          AT BCM MODULE IN PASSENGER KICKPANEL     
     Brake Lights          BROWN / GRAY          (+)          AT SWITCH ABOVE PEDAL     
     Modules          
     WIRE          LOCATION          
     Please select another category
     Doorlocks/Windows          
     WIRE          COLOR          POLARITY          LOCATION     
     Power Unlock          WHITE/ BLACK          (-)          AT BCM MODULE IN PASSENGER KICKPANEL     
     PowerLock          BLUE/RED          (-)          AT BCM MODULE IN PASSENGER KICKPANEL     
     Driver Mtr Unlock          WHITE          (REV)          AT MOTOR IN DOOR     
     Driver Mtr Lock          BLUE          (REV)          AT MOTOR IN DOOR     
     Pas Mtr Unlock          WHITE          (REV)          AT MOTOR IN DOOR     
     Pas Mtr Lock          BLUE          (REV)          AT MOTOR IN DOOR
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).
flexcar 
Member - Posts: 1
Member spacespace
Joined: April 05, 2007
Location: United States
Posted: April 05, 2007 at 2:29 PM / IP Logged  

This is only partially correct; the coupe version is different from the convertible.  There is no ignition switch harness anymore on the 07 coupes; instead there is a gray ribbon cable which leads up to the CAS module under the top dash flap from the key slot .  From there you may trace a thick gauge white wire down to the DS kick panel to a plug near the OBD connector.  That is your starter wire.

Ignition is a 14 gauge RED / Blk wire with yellow dots in a blue 10 pin plug in the passenger kick panel fuse box. Pin 2

Constant is a RED / White 12 gauge also at the top of the passenger fuse box in a Violet Plug, 2 pin.

Lock/Unlock:

Lock is a thin gauge Dark Blue/Violet in Driver door boot/kick space

Unlock is a thin gauge WHITE/ Blk in same location, but you still need to diode isolate these because a double pulse will lock the doors after unlocking....

lf
nealwm 
Member - Posts: 1
Member spacespace
Joined: May 15, 2007
Location: United States
Posted: May 23, 2007 at 2:28 AM / IP Logged  
I have a few questions along these same lines...I have a 2007 mini convertible on order and want to have an aftermarket alarm installed when I get the car. Does the remote start feature of an alarm have to be connected in order for a security system to function properly? Several 2 way alarms I have liked have remote start built in yet I do not want it (manual transmission). Also, where would I find the Tach wire and VSS wire on the 2007 mini convertible? Any help would be much appreciated. Also, any recommendations for an installer in the Studio City-Burbank area and/or San Bernardino area? Thanks

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, October 31, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer