ungo sr6000

Check the shutdown diagnostics.

1) with the ignition off, press and hold the valet/programming button

2) turn the ignition on and then back off while holding the valet/programming button

3) release the valet/programming button

4) press and release the valet/programming button. the LED will report the last shutdown for one minue or until the ignition is turned on.

LED Flashes                                        Shutdown Mode

one                                                       timed out

two                                                       over-rev shutdown

three                                                    low or no RPM

four                                                       transmitter shutdown (or optional push-button)

six                                                         (-) shutdown or (+) shutdown

seven                                                   (-) neutral safety shutdown

eight                                                     wait-to-start timed out

Reprogramming the tach signal

1) start the vehicle

2) press and hold the valet/programming button until the LED comes on solid.

3) release the valet/programming button and turn off the ignition

If the LED does not come on, then double check the connection for the tach reference.