DODGE / SPRINTER / 2007 / Security
[PRINT THIS PAGE]
12volts RED / gray (25A), RED / gray (10A) + ignition harness
Starter purple (not for remote start) + fuse box, rear 18 pin plug, pin 1
Notes: May not be able to do remote start on this vehicle because the ignition switch uses CAN data bus.
Ignition black + ignition harness
Power Lock use the motor wires 5wi
Notes: The driver door motor wires are dk. blue/red - dk. blue/black at the DDM, 20 pin plug, pins 12 and 11.
The passenger door motor wires are dk. blue/red - dk. blue/black at the BCM, brown 52 pin plug, pins 49 and 48.
The side and rear motor wires are dk. blue/brown - dk. blue/black at the BCM, black 12 pin plug, pins 12 and 11.
The DDM (Driver Door Module) is in the driver door.
The BCM (Body Control Module) is attached to the fuse/relay box in the driver kick panel.
Power Unlock use the motor wires 5wi
Lock Motor dk. blue/red 5wi DDM, 20 pin plug, pin 12
Notes: The DDM (Driver Door Module) is in the driver door.
Unlock Motor dk. blue/black 5wi DDM, 20 pin plug, pin 11
Notes: The DDM (Driver Door Module) is in the driver door.
Disarm Defeat dk. blue/black 5wi BCM, brown 52 pin plug, pin 48
Notes: The BCM (Body Control Module) is attached to the fuse/relay box in the driver kick panel.
Parking Lights+ gray/black (L), gray/red (R) + BCM, black 20 pin plug, pins 1, 12
Notes: The BCM (Body Control Module) is attached to the fuse/relay box in the driver kick panel.
Parking Lights- gray/white - BCM, brown 24 pin plug, pin 13
Notes: Parking lights are negative trigger thru a resistor. The resistor value is not known at this time. Cut this wire and meter the switch side to get the value.
The BCM (Body Control Module) is attached to the fuse/relay box in the driver kick panel.
Hazards (CAN data bus)
Turn Signal(L) BLACK/ wht (F), BLACK/ wht (R) + BCM, brn 52 pin plg; blk 20 pin plg
Notes: The BCM (Body Control Module) is attached to the fuse/relay box in the driver kick panel.
Turn Signal(R) blk/dk. grn(F), blk/dk. grn(R) + BCM, brn 52 pin plg; blk 20 pin plg
Notes: The BCM (Body Control Module) is attached to the fuse/relay box in the driver kick panel.
Door Trigger see notes - see notes
Notes: The LF door is dk. blue/dk. green at the DDM, 20 pin plug, pin 8. The RF door is dk. blue/dk. green at the BCM, brown 52 pin plug, pin 43. The LR door is yellow/white at the BCM, brown 52 pin plug, pin 4. The RR door is pink/white at the BCM, brown 52 pin plug, pin 41. Use all four wires and diode isolate each.
The DDM (Driver Door Module) is in the driver door.
The BCM (Body Control Module) is attached to the fuse/relay box in the driver kick panel.
Dome Supervision BROWN / dk. green - BCM, black 18 pin plug, pin 1
Notes: The BCM (Body Control Module) is attached to the fuse/relay box in the driver kick panel.
Trunk/Hatch Pin dk. blue/dk. green - BCM, black 20 pin plug, pin 6
Notes: The BCM (Body Control Module) is attached to the fuse/relay box in the driver kick panel.
Hood Pin BROWN / pink - BCM, brown 24 pin plug, pin 6
Notes: The BCM (Body Control Module) is attached to the fuse/relay box in the driver kick panel.
Trunk/Hatch Release N/A
Power Sliding Door N/A
Factory Alarm Arm factory remote only
Factory Alarm Disarm factory remote only
Disarm No Unlock with key sense and Transponder
Tachometer NOT BLACK/ white or BLACK/ gray ac any fuel injector
Notes: On diesel models, the tach wire is yellow/gray at the ECM, black 94 pin plug, pin 33.
The ECM (Engine Control Module) is on the driver fender behind the battery.
Horn Trigger dk. green + fuse box, rear 18 pin plug, pin 16
Memory Seat 1 N/A
Memory Seat 2 N/A
Memory Seat 3 N/A
Interface Module: Category:
Immobilizer Bypass Required:
Yes Type:
Transponder
Part #: 556UW
Alternate Part1 #: DesignTech 20402
Alternate Part2 #: DesignTech 29402
Notes: Standard on all models. May not be able to do remote start on this vehicle because the ignition switch uses CAN data bus.
Smart Starter Kill Relays: Not Available
wire4veins
"D"
Precision Autosound - Owner
MECP Master Installer