stratus wire starter kill

Home / the12volt's Install Bay / Car Security and Convenience / stratus wire starter kill (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

flint28no

Member - Posts: 2

Joined: September 17, 2007

Location: Sweden

Posted: September 27, 2007 at 3:38 PM / IP Logged

I just bought a VIPER alarm, i'm a bit confused about the wiring of the starter kill relay. Wires on the starter kill relay are GREEN, BLACK, 2 YELLOWS connected to each othe one goes to the ALARM Harness and one is loose, ORANGE goes to the alarm harness.

The manual says Green wire from the Pre-Wired starter kill relay goes to the ignition harness and the black goes to the starter motor, whick wire do i use in the ignition harness for the green wire on the starter kill relay?

Ignition wire harness

Constant 12V+	Red or Pink/Black or RED / Blue	Ignition Switch Harness
Starter	Yellow	Ignition Switch Harness
Ignition	Dark Blue	Ignition Switch Harness
Ignition 2	Dark GREEN/ Red	Ignition Switch Harness
Ignition 3	BLACK/ White	Ignition Switch (Power, Heat

The manual says also that the yellow wire should be connected to the ignition system. is this the Dark blue on this table? and the black wire from the starter kill relay that supposed to go to the starter motor, can i use the yellow wire in the ignition harness for this?

I made some drawing of how i understand it. Can someone help me to point were to connect the wire from the relay to the ignition harness ?

THE IMAGE I MADE

http://www.bicoluragon.com/wiring2.jpg

techman93

Silver - Posts: 591

Joined: October 28, 2006

Location: Pennsylvania, United States

Posted: September 29, 2007 at 1:38 PM / IP Logged

For starter kill.

You must cut yellow wire and the side that comes from the "key side" gets connected to the green wire then the other side gets connected to the black wire. The yellow ignition wire then gets connected to the dark blue wire. That will energize the coil of the relay and make it so when the alarm is armed, the starter wire will not get 12v supply.

techman93

Silver - Posts: 591

Joined: October 28, 2006

Location: Pennsylvania, United States

Posted: September 29, 2007 at 1:40 PM / IP Logged

and orange goes to the (-) output wire on alarm, normally the same color of orange

flint28no

Member - Posts: 2

Joined: September 17, 2007

Location: Sweden

Posted: October 05, 2007 at 1:40 PM / IP Logged

Thanks a lot, 4 your help i got it working now :)) stratus wire starter kill -- posted image.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

stratus wire starter kill

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.