push starter

I need help installing a push button starter with relay. I have 2 starter input and need how to wire it for IGNITION SWITCH HARNESS 2 relay a diagram would help 12 VOLT CONSTANT WHITE (+) STARTER BLACK/ WHITE (+) STARTER 2 BLACK / YELLOW (+) IGNITION 1 BLACK/ RED (+)      ACCESSORY /HEATER BLOWER 1 WHITE/ BLUE (+)

Assuming the feed from the switch to the supplied relay is POS, (TEST) use this diagram, 2nd._relay.bmp if it's NEG, let me know.

do you have a drawing of two relay. the one post is good. thanks

Post the original drawing especially the relay wiring please.

you need two relays. If push button starter has two wires. one side to ground-other wire to relay #85 (to relay 1 and 2) 86-30 to blk/red (ign) with 10amp. fuse     cut blk/white wire 87a to blk/white toward switch 87 to blk/white away from switch second relay 86-30 blk/red (ign) 10amp. fuse cut blk / YELLOW 87a blk / YELLOW toward switch 87 to blk / YELLOW away from switch to start you car turn ign. on - and then push start button for 1 second.