DIRECTWIRE™ WIRING INFORMATION - TOYOTA / 4RUNNER / 2004 / Security
12volts WHITE/ blue and red + ignition harness
Starter GREEN/ black + ignition harness
Ignition BLACK/ red + ignition harness
Power Lock blue - driver kick, 18 pin plug
Notes: Meter the wire while turning the key in the driver door key cylinder.
Power Unlock green (double pulse) - driver kick, 18 pin plug
Notes: Meter the wire while turning the key in the driver door key cylinder.
Lock Motor blue/red to BLACK/ white 5wi driver kick, 13 pin plug
Unlock Motor blue/black to BLACK/ red 5wi driver kick, 13 pin plug
Disarm Defeat blue/black 5wi driver kick, harness to rear
Parking Lights+ green + left of fuses, 16 pin plug
Parking Lights- green - pin 8, top plug at BECU
Notes: The Body ECU is part of the fuse box under the driver side dash. The three plugs on the right side edge of the fuse box are for the Body ECU.
Hazards white - hazard switch
Turn Signal(L) blue/black + left of fuses, 16 pin plug
Turn Signal(R) blue / YELLOW + left of fuses, 16 pin plug
Door Trigger purple / YELLOW - pin 12, top plug at BECU
Notes: Can also use individual door trigger wires in the middle plug at the BECU. The driver door trigger is RED / black in pin 23, the passenger door is RED / yellow in pin 24, the left rear door is pink/black in pin 11, and the right rear door is pink/blue in pin 12. Use all four wires and diode isolate each.
The Body ECU is part of the fuse box under the driver side dash. The three plugs on the right side edge of the fuse box are for the Body ECU.
Dome Supervision white - plug to right of fuses, pin 8
Trunk/Hatch Pin GREEN/ YELLOW - back door ECU in hatch
Hood Pin pink/green - driver kick, blue 18 pin plug
Trunk/Hatch Release N/A
Power Sliding Door N/A
Factory Alarm Arm arms with lock
Factory Alarm Disarm disarms with unlock
Disarm No Unlock use key sense wire
Tachometer BLACK/ white ac pin 5, conn. E8 at ECM
Notes: The ECM (Engine Control Module) is behind the glove box. Connector E8 is the bottom plug.
Horn Trigger GREEN/ red - steering column
Memory Seat 1 N/A
Memory Seat 2 N/A
Memory Seat 3 N/A
Interface Module: Category:
Required:
Yes Type:
Transponder
Part #: 556U or 555U
Notes: N/A
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.
Be careful whose advice you buy, but be patient with those who supply it.