2005 Mazda 6 Alarm/Remote Start Wiring

Home / the12volt's Install Bay / Vehicle Wiring Information & File Requests / 2005 Mazda 6 Alarm/Remote Start Wiring (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

zfactor

Member - Posts: 22

Joined: June 09, 2005

Location: United States

Posted: July 12, 2005 at 1:10 PM / IP Logged

just need a wiring sheet for this car (alarm/remote start) preferably directechs but anything will help thanks

chungo

Copper - Posts: 135

Joined: December 31, 2003

Location: United States

Posted: July 12, 2005 at 5:09 PM / IP Logged

DIRECTWIRE™ WIRING INFORMATION - MAZDA / 6 / 2005 / Remote Start

[PRINT THIS PAGE]

12volts	black (40A), BLACK/ yel (30A)	+	ignition harness
Starter	BLACK/ blue	+	ignition harness
Second Starter	N/A
Ignition	blue	+	ignition harness
Second Ignition	N/A
Third Ignition	N/A
Accessory	BLACK/ red	+	ignition harness
Second Accessory	BLACK/ white	+	ignition harness
Keysense	WHITE/ blue	+	ignition harness
Notes: Using the status output from the remote start to trigger this wire will disarm the factory alarm without unlocking the doors.
Power Lock	lt. green	-	driver kick or door lock module
Notes: Lock is negative trigger thru a 1000 ohm resistor. Unlock is a straight negative trigger. MUST use relays. The door lock control module is located above the passenger kick panel.
Power Unlock	same as power lock wire
Lock Motor	RED / blue	5wi	driver kick or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Unlock Motor	RED / green	5wi	driver kick or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Parking Lights+	lt. GREEN/ black	+	driver kick, 14 pin plug
Parking Lights-	RED / white	-	headlight switch
Hazards	blue/orange	-	switch or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Turn Signal(L)	WHITE/ black	+	turn signal switch
Turn Signal(R)	WHITE/ red	+	turn signal switch
Reverse Light	RED / yellow	+	driver kick, 14 pin plug
Door Trigger	GREEN/ orange	-	driver kick or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Dome Supervision	yellow/black	-	driver kick or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Trunk/Hatch Pin	brown	-	driver kick or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Hood Pin	gray/red	-	pin switch or theft module
Notes: The theft-deterrent control module is located in the center console.
Trunk/Hatch Release	yellow	-	switch or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Power Sliding Door	N/A
Factory Alarm Arm	blue	-	driver kick or door lock module
Notes: Arm is negative trigger thru a 1000 ohm resistor. Disarm is a straight negative trigger. MUST use relays. The door lock control module is located above the passenger kick panel.
Factory Alarm Disarm	same as factory alarm arm wire
Disarm No Unlock	use key sense wire
Tachometer	NOT blk/wht or grn/stripe	ac	any ignition coil or coil pack
Notes: On the 4 cyl models use the wire that is NOT BLACK/ white. On the 6 cyl models use the wire that is NOT GREEN/ stripe.
Wait to start	N/A
Brake Wire	GREEN/ YELLOW	+	brake pedal switch
Parking Brake	brown	-	parking brake switch
Horn Trigger	PURPLE / white	-	switch or door lock module
Notes: The door lock control module is located above the passenger kick panel.
Memory Seat 1	N/A
Memory Seat 2	N/A
Memory Seat 3	N/A

Interface Module:	Category: Immobilizer Bypass	Required: Yes	Type: Transponder
Part #: 556UW
Alternate Part1 #: 555U
Notes: Standard on all models.
Interface Module:	Category: Door Lock Interface	Required: Yes	Type: Multiplex
Part #: 456LW
Notes:

zfactor

Member - Posts: 22

Joined: June 09, 2005

Location: United States

Posted: July 12, 2005 at 11:39 PM / IP Logged

thanks so much

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

2005 Mazda 6 Alarm/Remote Start Wiring

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.