flashing lights/ hood switch wires

Home / the12volt's Install Bay / General Discussion / flashing lights/ hood switch wires (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

Mauricio

Member - Posts: 13

Joined: March 18, 2003

Location: United States

Posted: June 09, 2004 at 3:46 PM / IP Logged

Hi, I have a remote starter/car alarm installed on my ford explorer 1997, but where can I connet the white wire that comes for the flashing lights and also where can I connect a negative blue wire that goes connected to the hood switch,

thx for any help.

forbidden

Platinum - Posts: 5,352

This member has made a donation to the12volt.com. Click here for more info.

This member has been recognized as an authority in Mobile Audio and Video. Click here for more info.

Joined: November 01, 2003

Location: Alberta, Canada

Posted: June 09, 2004 at 5:02 PM / IP Logged

Most vehicles you must install a hood pinswitch into for the remote start, it should have come with the remote starter. The park light wire in this vehicle should be a white / black wire at the switch on the dash. Do a search on this site for this vehicle and more info should be found about it there.

Top Secret, I can tell you but then my wife will kill me.

Mauricio

Member - Posts: 13

Joined: March 18, 2003

Location: United States

Posted: June 10, 2004 at 8:27 AM / IP Logged

forbidden wrote:

Thank you for the info Forbidden!!!

Mauricio

deviousjoker

Copper - Posts: 102

Joined: April 22, 2004

Location: United States

Posted: June 10, 2004 at 9:55 AM / IP Logged

you can also go to your drivers kick panel and grab your parking lights the wire is PURPLE / white and while you're in your kick panel the hood pin is tan/lt. green

First Class MECP Installer

Mauricio

Member - Posts: 13

Joined: March 18, 2003

Location: United States

Posted: June 10, 2004 at 11:16 AM / IP Logged

Thanks also to you deviousjoker, I will try that also, another question, when I engage the remote start, the 4x4 high/4x4 low lights keeps on flashing every a few minutes, only when I engage the remote/start, does is that normal or there is some wire not connected properly?

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

flashing lights/ hood switch wires

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.