Making fiberglass molds stay

Home / the12volt's Install Bay / Fiberglass, Fabrication, and Interiors / Making fiberglass molds stay (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

mob.dynam.grad

Copper - Posts: 73

Joined: May 23, 2004

Location: Canada

Posted: July 08, 2004 at 1:52 PM / IP Logged

I just have a question about making fiberglass molds and how to get them to stay up. I am working on a 93 Astro van and i removed covers in the back of the van in order to mold in the fiberglass and make a sub enclosure for each side. I am just wondering after i make it...i want it to be removable. But i dont want it falling out if he goes over a speed bump. Any ideas on how to make the mold with the sub in it stay up would be greatly appreciated.

Dave

Back to Top

Search for other posts by mob.dynam.grad

defective

Silver - Posts: 642

Joined: August 20, 2003

Location: Canada

Posted: July 08, 2004 at 3:26 PM / IP Logged

usebolts with rubber washers to hold them to the doors, accessable when the subs are removed

Back to Top

mob.dynam.grad

Copper - Posts: 73

Joined: May 23, 2004

Location: Canada

Posted: July 11, 2004 at 1:09 AM / IP Logged

would that still make it air tight for a sub enclosure if i have the bolts just coming through the enclosure? Or are the rubber washers for that as well as preventing rattle??

Back to Top

defective

Silver - Posts: 642

Joined: August 20, 2003

Location: Canada

Posted: July 11, 2004 at 10:57 AM / IP Logged

both...

Back to Top

pureRF

Silver - Posts: 619

Joined: July 22, 2003

Location: United States

Posted: July 11, 2004 at 11:55 AM / IP Logged

u should also cover the bolt from the inside of the box with silicone caulk.

dream it, build it, fiberglass it

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Making fiberglass molds stay

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.