PVa mold release

Home / the12volt's Install Bay / Fiberglass, Fabrication, and Interiors / PVa mold release (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

jman7695

Member - Posts: 9

Joined: March 25, 2004

Location: United States

Posted: August 25, 2005 at 6:57 PM / IP Logged

Just created a mold of the back side of the fact. box in 04' Navigator. I used poly vinyl alcohol as the release agent. the mold came out great, but before I set a woofer ring and lay fleece should worry about the old PVA on it. just want the new glass to stick.

Thanks

JDm

70% installation, 28% product, 2% luck, try to be the best everytime!

Back to Top

realitycheck

Silver - Posts: 751

Joined: September 09, 2004

Posted: August 26, 2005 at 7:40 AM / IP Logged

I would just wipe down the area that the fleece is going to stick to with rubbing alcohol or something. Then hot glue that bad boy.

Learning the trade one fiberglass creation at a time!

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

PVa mold release

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.