filler for plastic

Home / the12volt's Install Bay / Fiberglass, Fabrication, and Interiors / filler for plastic (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

78musicman

Copper - Posts: 78

Joined: August 10, 2005

Location: United States

Posted: December 31, 2005 at 1:16 PM / IP Logged

I am installing a monitor into the dash.I am going to need to rework to radio bezel and fill in some to make the hole smaller.Up to 1/4 inch.Should i use bondo resin in deep areas and bondo to finish or will any of this eat at the plastic or even stick.New to this thanks.

colorado tap the rockies

Back to Top

g-twizzl

Member - Posts: 20

Joined: April 23, 2005

Location: United States

Posted: January 01, 2006 at 2:33 AM / IP Logged

if you're doing more than one job i would try duramix 4040 and 4058 paste, it's usually used to repair bumpers but should be available at your local automotive paint store. if this is the only thing in the near future, try a tube of plastic filler from the auto parts store.

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

filler for plastic

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.