Switchs

Home / the12volt's Install Bay / Lights, Neon, LEDs, HIDs / Switchs (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

lutz07

Member - Posts: 1

Joined: July 18, 2005

Location: United States

Posted: July 18, 2005 at 6:28 PM / IP Logged

alright i got a question...i got 2 10inch neon sticks...i was wondering if there is an easy way to install a toggle switch on my dash and can turn the lights on and off...if there is how would i got about doing so?

Back to Top

nowlater123

Copper - Posts: 61

Joined: June 24, 2005

Location: United States

Posted: July 18, 2005 at 6:46 PM / IP Logged

Very simple.

All you need is a 12volt relay, a switch, and some wire. Find out where you want to install the switch, and the relay. Run the wires through to where the switch and relay are going to be. Attach power wire to battery, to the switch, and to the relay. Ground the relay and run the power wire that comes off the relay to the neons. Then just ground the neons and you're finished. Use the diagram on the relay box for all the conections.

Kenwood all the Way!

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Switchs

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.