mtx thunder8 1000d 2 channel

Home / the12volt's Install Bay / Car Audio / mtx thunder8 1000d 2 channel (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

hookedonaudio

Member - Posts: 21

Joined: March 11, 2008

Location: Kentucky, United States

Posted: January 24, 2009 at 2:35 AM / IP Logged

I have a mtx thunder8 1000d 2 channel and 1 kicker L7 dvc square sub, is there any way to bridge this amp to 1 sub because there is no diagram or info on bridging this amp in the manual( would it be safe to run 1 channel to each voice coil.

Back to Top

i am an idiot

Platinum - Posts: 13,667

This member consistently provides reliable information

Joined: September 21, 2006

Location: Louisiana, United States

Posted: January 24, 2009 at 4:48 AM / IP Logged

That is a 1 channel amplifier. It is stable down to 2 ohms. If your speaker is a dual 4 ohm driver, then you can connect one voice coil to each set of terminals. If it is a dual 2 ohm driver you will need to wire the voice coils in series.

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

mtx thunder8 1000d 2 channel

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.