07 matrix integration

Home / the12volt's Install Bay / Car Audio / 07 matrix integration (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

TheDouche

Copper - Posts: 93

Joined: March 24, 2005

Location: United States

Posted: March 26, 2009 at 8:01 PM / IP Logged

hey guys i was just wondering if you could point me in the right direction for this. a friend of mine wants me to add a sub to her toyota matrix. what PAC product would i use to add a sub amp onto the factory radio? which PAC LOC? ive never done a LOC but do they install by the radio or by a speaker? she also wants a iPod integration. they dont seam to hard to do i just would like to get your guys opinions if im doing it the right way and all. thanks!

Back to Top

i am an idiot

Platinum - Posts: 13,670

This member consistently provides reliable information

Joined: September 21, 2006

Location: Louisiana, United States

Posted: March 26, 2009 at 8:35 PM / IP Logged

This one gives you a remote out to turn on the amplifier.

Part Number: Trunk-LOC

The Trunk-LOC is the same as the SNI-35 below but with a low voltage trigger built into it. The low voltage circuit senses voltages as low as 0.8 volts and gives you a 12 volt output with a one second delay.

• Trigger off of speaker leads or +5 volt remote wires.

• Remote turn on for aftermarket amplifiers in vehicles without a factory remote wire.

• Eliminates turn on pops in amplifiers.

Instructions

Application Guide

This one does not provide the remote output.

Part Number: SNI-15

SNI-15 converts 10 to 30 watts per channel speaker level output into a pre-amp signal. Perfect when adding an amplifier to a factory or aftermarket radio. Great for getting an additional set of pre-amps outputs from a head unit equipped with only one set.

• Fixed 10:1 conversion.

• Linear from 20-20,000Hz at +/- 5 dB, while maintaining signal phase.

• Isolates input and output circuits to prevent ground loop noise.

White: Left(+) speaker

WHITE/ Black: Left(-) speaker

Grey: Right(+) speaker

Grey/Black: Right(-) speaker

FAQ's

Application Guide

Back to Top

TheDouche

Copper - Posts: 93

Joined: March 24, 2005

Location: United States

Posted: March 26, 2009 at 9:00 PM / IP Logged

how would you go about installing the Trunk-LOC? do you just wire it up to a speaker or how does that work? is that the only thing i can do for her car?

Back to Top

TheDouche

Copper - Posts: 93

Joined: March 24, 2005

Location: United States

Posted: March 31, 2009 at 9:37 PM / IP Logged

anything on the Ipod integration? or is that something super special?

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

07 matrix integration

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.