how to a eqs746?

here is what i have install in my 93 camry: ida-x200 mrp-m500 12" alpine type r rf punch 240x4 6022i's sps-69c3's rfc1d can someone please tell me how to install this EQ and if i need any additional items. thanks.

Follow the instructions in the owner's manual would be a good place to start.  In case you don't have one.Support the12volt.com

Nice choice....its pretty clean. If you have a media player, especially "anti ipod" then there's a separate input with level controls for that. Thats the reason I got it. Other than that, it takes 1 input and now Fader, Vol and sub all control from there. FUSE the 12V+, I cant remember the fuse rating though, I wanna say 2A. Maybe an idiot can figure it out. 100db s/n --JHEA!!   7V pre-out works well with the MRP.   0.005% THD dude your stoked! Here's how I put mine in. I cut plexi-glass to fit over the hole. It was a small compartment before. Then just veneered it with carpet. I used 2 layers of carpet to make it appear recessed, or somewhat flush. I'm constantly boosting 16k and cutting 315k when playing Mp3's.This is what I do for FUN!

"FUSE the 12V+, I cant remember the fuse rating though, I wanna say 2A" what do you mean by this? regarding the "main in" on the EQ; where does the other end of the RCA go to? to the deck right? but which preamp out? front, rear, or sub?