Hitron HB-2 Bass Knob Replacement Cable

I picked up the HB-2 bass processor but did not get the 6 wire RJ-45 cable with it. Looking at the ends with the clip side down I have from left to right ; blue , yellow , green , red , black , white and then the oposite on the other end ; white , black , red , green , yellow and blue. I am not sure what pairs to solder after I cut the cable in half to make it work. Hope this makes sense. Thank you in advance.BassHeadz4Life

If the cable you have came from a telephone system, you need to cut the cable and flip it. Solder 1 to 6. 2 to 5 and 3 to 4.

So blue to white. Yellow to black. Green to red. What about wire 4,5,and 6 from cable side (A)? I am designating the cable half that starts with blue yellow ... as cable (A)BassHeadz4Life

Did the cable you have come from a phone system? If so, Blue to White. Yellow to Black. Red to Green.

I have no idea where the cable came from. All I know is that the 6 wires are flipped at one end meaning that it starts with white , black etc... exact opposite of the other end. Are you saying to only solder the 3 pairs of wires that you said? Do I leave the remaining 3 pairs disconnected? The bass processor has 2 knobs on the bass controller if that helps.BassHeadz4Life