the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

04 mazda3 stereo diagram


Post ReplyPost New Topic
< Prev Topic Next Topic >
mr.box 
Member - Posts: 2
Member spacespace
Joined: July 04, 2003
Location: United States
Posted: April 29, 2004 at 4:19 PM / IP Logged  

Hi,does anyone know the wireing diagram for the mazda3 its a 2004.if theres anyone out there that knows the stereo wiring on this vehicle,please respond..

thanks for all your help!!!!!

Mr. Box
superfinechef 
Member - Posts: 2
Member spacespace
Joined: March 21, 2004
Location: United States
Posted: May 18, 2004 at 6:15 PM / IP Logged  
i'm doing an install in bout 30min from now i will let u know later what the wires r
"Keep your stick on the ice" Red Green
raydawg357 
Silver - Posts: 769
Silver spacespace
Joined: June 17, 2003
Location: United States
Posted: May 20, 2004 at 9:19 AM / IP Logged  
DIRECTWIRE™ WIRING INFORMATION - MAZDA / 3 / 2004 / Remote Start
[PRINT THIS PAGE]
12volts red (30A), BLACK/ red (30A)  +  ignition harness
Starter gray/black  +  ignition harness
Second Starter N/A    
Ignition GREEN/ YELLOW  +  ignition harness
Second Ignition N/A    
Third Ignition N/A    
Accessory pink / YELLOW  +  ignition harness
Second Accessory yellow  +  ignition harness
Keysense RED / black  +  ignition harness
Power Lock GREEN/ red  -  driver kick, door harness
Notes: Lock is negative trigger thru an 1,000 ohm resistor. Unlock is a straight negative trigger. MUST use relays.
Power Unlock same wire as power lock    
Lock Motor yellow/black  5wi driver kick, door harness
Unlock Motor WHITE/ black  5wi driver kick, door harness
Parking Lights+ ORANGE / white (L), orange (R)  +  passenger kick, harness to rear
Parking Lights- BLACK/ white  -  headlight switch
Hazards BLACK/ orange  -  hazard switch
Turn Signal(L) blue  +  passenger kick, harness to rear
Turn Signal(R) blue/red  +  passenger kick, harness to rear
Reverse Light GREEN/ orange or GREEN/ black  +  passenger kick, harness to rear
Door Trigger see notes  -  passenger kick, harness to rear
Notes: The LF door is BLACK / YELLOW, the RF door is BLACK/ blue, the LR door is BLACK/ orange, and the RR door is BLACK/ green. Use all four wires and diode isolate each. These wires are also found at the Passenger Junction Box behind the glove box.
Dome Supervision BLACK/ blue to BLACK/ red  -  passenger kick, harness to rear
Trunk/Hatch Pin BLACK/ red or BLACK/ blue  -  passenger kick or light in trunk
Hood Pin BLACK / YELLOW  -  hood pin switch
Trunk/Hatch Release N/A    
Power Sliding Door N/A    
Factory Alarm Arm BLACK/ blue  -  driver kick, door harness
Factory Alarm Disarm BLACK/ white  -  driver kick, door harness
Disarm No Unlock     
Tachometer NOT GREEN/ stripe  ac  any ignition coil or fuel injector
Wait to start N/A    
Brake Wire RED / white  +  brake pedal switch
Parking Brake BLACK/ lt. green  -  parking brake switch
Horn Trigger black  -  steering column
Memory Seat 1 N/A    
Memory Seat 2 N/A    
Memory Seat 3 N/A    
04 mazda3  stereo diagram -- posted image.
Immobilizer Bypass Module:Required: YesType: TransponderPart #: 555U
Notes: N/A
Do it right the first time
superfinechef 
Member - Posts: 2
Member spacespace
Joined: March 21, 2004
Location: United States
Posted: May 26, 2004 at 2:03 PM / IP Logged  
i have been installing for years and i'm certified but i'm not sure where to start to remove the the deck in the mazda3 ...i'm kinda of cuz the customer insists on being able to watch the install...which put s more pressure on me and honestly i don't want to make a mistake...I NEED TO KNOW HOW/WHERE TO START TO REMOVE THE STEREO AND ANY CODES THAT COULD HELP
THANK YOU FOR YOUR HELP04 mazda3  stereo diagram -- posted image.
"Keep your stick on the ice" Red Green
Velocity Motors 
Moderator - Posts: 12,488
Moderator spaceThis member has made a donation to the12volt.com. Click here for more info.spaceThis member has been recognized as an authority in Electrical Theory. Click here for more info.spaceThis member has been recognized as an authority in Fabrication. Click here for more info.spaceThis member has been recognized as an authority in Mobile Audio and Video. Click here for more info.spaceThis member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.spacespace
Joined: March 08, 2002
Location: Manitoba, Canada
Posted: May 26, 2004 at 5:43 PM / IP Logged  
The Mazda is just like all the Ford's. You need a key to remove the deck from the OEM location. These keys are required for removal of the deck. There should be 4 holes ( 2 on each side of the deck ) that you need to insert the keys into and pull all 4 keys to the side to release the locking tabs.
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Saturday, April 27, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer