amp and sub set up

Home / the12volt's Install Bay / Car Audio / amp and sub set up (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

gicts

Member - Posts: 11

Joined: April 29, 2005

Posted: May 16, 2005 at 5:47 PM / IP Logged

I rencently got 2 2 ohm Alpines that are 300 RMS each and a 2 channel amp that 300X2 RMS @ 2 ohms. What ohm load would you recommend I set the subs for?

Back to Top

Ravendarat

Platinum - Posts: 2,806

Joined: February 23, 2004

Location: Canada

Posted: May 16, 2005 at 5:52 PM / IP Logged

Well if the subs are 2 ohm and the amp is 300x2 at two ohms i would just wire one sub to each channel and let it rip. It matches up perfect so I think this is a easy choice.

double-secret reverse-osmosis speaker-cone-induced high-level interference distortion, Its a killer

Back to Top

gicts

Member - Posts: 11

Joined: April 29, 2005

Posted: May 16, 2005 at 7:32 PM / IP Logged

just making 100% sure, I should set the ohm load as 2, right? I have heard it should be at 4 as well as 8

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

amp and sub set up

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.