How to Wire it? Audiobahn AW1000Q

Hi. I just got this woofer box with an amplifier Boss 535 800W and an Audiobahn AW1000Q. I need help how to wire the speaker to the amp. The speaker has 2 sets of connectors on each side. Pictures attached. I appreciate the help. Thanks.

It would be very helpful if you were to give the impedance(ohms) of each coil on that woofer, and the power rating on the amp

The speaker has 4 ohms each coil at RMS 600W / 1200W Peak. When I opened the sub box there were 2 sets of wires. 1 set on each side but only 1 set was connected to the amp and the other was disconnected. Thanks.

I got this from their site.     * Optimized for Maximum Sound Quality / SPL     * PHAT 2” Foam Surround     * 120 oz. Magnet     * Non-Pressed, Non-Transfer Paper Cone     * KM3 Coated Cone for Low Cone Distortion     * Bolt-Tight Cast Flame Basket     * Multi-Connect Lug-Lock Terminals     * Mounting Depth: 5”     * Hole Cutout: 9 1/4”     * Outer Diameter: 10 7/8” Subwoofer Specifications     * Size: 10 inch     * Rec. Sealed Box Dims: .25 - .75 cu.ft.     * Rec. Ported Box Dims: .65 - 2.35 cu.ft     * Free Air Usage: not recommended     * Sensitivity: 91.1 dB     * Frequency Response: 23-500 Hz     * Recommended RMS Power: 600W     * Peak Power Handling: 1200W     * Impedance: dual 4 ohms subwoofer wiring options