chrysler factory stereo

Home / the12volt's Install Bay / Car Audio / chrysler factory stereo (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

zapgap

Member - Posts: 1

Joined: August 11, 2006

Location: United States

Posted: August 13, 2006 at 4:48 PM / IP Logged

I have a mid-90s chrylser factory stereo that was removed from the vehicle to install after aftermarket upgrade. I want to use it as my shop radio but i can't get it working. I have the speakers hooked up correctly, ground hookedup, and plus 12 to the power pin and the ignition pin. I can get scratching noises in the speakers when turn the balance and fade controls etc and on applying the 12 volts to the ignition pin but the display will not fire up and cannot tune anything etc. Is there a secret procedure or a security code on these things i need to apply or some other ideas to get me going thanks

zapgap

saxdogg

Member - Posts: 12

Joined: December 01, 2004

Posted: August 13, 2006 at 7:26 PM / IP Logged

This ? may be stupid, but was it removed because it didn't work?

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

chrysler factory stereo

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.