Amp and Sub Wiring

Home / the12volt's Install Bay / Car Audio / Amp and Sub Wiring (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

pmtcfhm

Member - Posts: 1

Joined: October 19, 2002

Location: United States

Posted: January 21, 2003 at 2:50 PM / IP Logged

I have a 2 ch Kenwood ks-729 amp and (2) Kenwood 10" subs, SVC, 4 ohms. What would be the best configuration for the subs to get the most power.

auex

Platinum - Posts: 5,041

This member has made a donation to the12volt.com. Click here for more info.

Joined: December 23, 2002

Location: Arizona, United States

Posted: January 21, 2003 at 8:59 PM / IP Logged

Pretty much the only way you should wire the subs is in series for a 8 ohm load. If you wire them parellel you would get a 2 ohm load but the amp would overheat or might go into protection. That amp is only stable to 4 ohms bridged. You can try either way but you should make sure your warranty is still in effect if you go 2 ohms.

Certified Security Specialist

Always check info with a digital multimeter.

I promise to be good.

Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Amp and Sub Wiring

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.