pkuf2 for 2002 ford taurus

I would use the first set of instructions you have. I don't use that brand of bypass, but looks like a standard transponder bypass. When you get to the step where you have to remote start the vehicle, get the box as close as possible to that black ring i was telling you about. When you remote start the vehicle, it is basically using the remote start to turn on the ignition.......instead of having to jump the ignition wire. This will program the module to the car. If it starts, then you know you got it programmed. If the security light on the dash blinks fast, then you know the module didn't program.

Just a little side note......before i even put the bypass module in the vehicle, i test the remote start out first. once you've got all the wiring completed, and are ready to test.....just put one of the keys in the ignition cylinder....don't turn it at all. This will simulate what the bypass is gonna do. If it starts correctly then go ahead and install the bypass. i do this, that way if i have a failure, i know for sure it's not the bypass.

Insert 1st valid Ign. key & turn to “ON” position until security light turns off. Remove 1st valid key.

Insert 2nd valid Ign. key & turn to “ON” position until security light turns off. Remove 2nd valid key.

Position & hold PKU module (screw side) towards the front of the ignition barrel (key cylinder), then

start vehicle by remote start. (IF vehicle does not start and/or run, please repeat Steps 1, 2 & 3).

The PKU module is now programmed