Hi check level Low check Autopage750

Home / the12volt's Install Bay / Car Security and Convenience / Hi check level Low check Autopage750 (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

floaterr

Silver - Posts: 383

Joined: December 07, 2002

Location: United States

Posted: February 25, 2003 at 3:28 PM / IP Logged

What is the low check and high check on the programming of the remote start on the Autopage 750LCD?

I have an autopage that cranked to fast to start the vehicle and then with voltage sensing didnt notice that the truck failed to start and sent the started signal to the remote. Would this setting correct that issue?

securinu

Silver - Posts: 772

This member has made a donation to the12volt.com. Click here for more info.

Joined: September 15, 2002

Location: United States

Posted: February 25, 2003 at 3:39 PM / IP Logged

the hi check and lo check is in regards to the tach wire . some cars have computers with higer voltages . this only come into play when tach wire is connected and wont start all the time. you can switch to lo and see if it works.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Hi check level Low check Autopage750

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.