08 explorer door trigger?

I installed an Autopage RS-727 LCD on an 08 Explorer and when I go to use the remote start sometimes it says the door is open when their all closed. the bypass module I used controls the doors through the data bus on the OBDII what can I do to correct this use a diode? If so where would I put the diode? Thanks

Correct me if im wrong. I haven't seen one module that can control the doorlocks on Ford yet. BTW what module do you use ?

woops sorry wrong car, I did a '05 silverado the same time and got them mixed up.

wsc75 wrote: woops sorry wrong car, I did a '05 silverado the same time and got them mixed up.

This makes more sense. What module did you use? This sounds like the module is turning on the dome light as part of it's disarm sequence. I do not believe that you can change this.Installer, IT support, and FFL. I need less hobbies.

556U immobilizer interface. I don't have the factory arm or disarm wires connected or the dome light suppervision. I think this is my problem. I don't know where to connect the arm and disarm wires. Sorry for the slow response, but I really do appreciate everyones help.

wsc75 wrote: 556U immobilizer interface

OK, I think you need to stop and regroup here. You did not use a 556U in an 05 Silverado. Because the 556U does not work in the 05 Silverado and if you did the truck would not remote start. So why not start over and explain the problem(s) you are having with the vehicle from the beginning. If it is the Explorer and you do not want the indicator to come on then you need to isolate the door triggers and not use the dome light trigger for the alarm. How to do this is explained in great detail several times over on this site.Installer, IT support, and FFL. I need less hobbies.

Ok I got all screwed up here. The problem im having with 2008 Explorer is I go to remote start it and the LCD screen on the remote acts as if it did start and then the door flashes like its open but the truck never starts. Sorry and thanks for being here with a response.

What happens in the truck when this goes on? Does the theft indicator in the dash flash? Does it attempt to start at all? Does the dome light in the vehicle come on when the 'door flashes'?Installer, IT support, and FFL. I need less hobbies.

If you used a 556U in the 08 Explorer and the theft light is flashing rapidly when you try to RS the truck you need to adjust the ring so that the truck can see it. The truck is not picking up the signal from the ring, OR there is a problem with your gwr or constant hot feeds to the bypass module.Installer, IT support, and FFL. I need less hobbies.