astroflex 3106 u

hi, i'm new overthere and after few search in you forum and on the net i cannot find any information about the astroflex 3106 U.

i try to find where to hock up my alarm LED.

basicly, i bought a car and the guys before me have done a pretty bad instalation, so i've got to do it again.

i fix every thing , except the damn LED.

i doesen'T have the particular wiring diagram for the 3106 U , but on from serie 500-1100-2100-4100.

so is somebody can help me out how to figure my LED !

ps: where i can find a nice one ? like a blue or something , is they are available at The source ? something easy to instal.

thank guys !

The older astro LEDs sucked. Very dim. I have tried to replace the LED with a DEI, and a Compustar blue. Still very dim.

The led plugs into the P-9 plug under the flapper. it's the smallest plug On the back of the unit it will show you.

Let me know!

so basicly, you ground the LED somewhere and plug the power wire on P-9 ??

oh, on the 3106 U you get the conector P2 with 16 wires , P3 with 6 conectors , p4 with 7 conector , p5 with 3 and the accesorie plug in with P1- to P16

can you explain it a bit more please (i'm french so i mabey don'T understand every thing ;)

what that mean : The led plugs into the P-9 plug under the flapper. it's the smallest plug On the back of the unit it will show you.

thank you very mutch !

PM me your email address I can send you the install manual (if you don't have it) and it will be in French as well.

The P9 is a direct plug for the LED. Just plug it in.