2007 silverado remote start
Welcome Guest :)
downlowez
Member -
Posts: 6
Joined: September 23, 2003
Location: Albania
Posted: April 22, 2008 at 7:22 PM / IP Logged
hey. i am going to install a viper 791 in my 07 silverado and was looking for the wiring and other info. could someone help a brother out?? thanks in advance !!!!
Downlowez,,
Velocity Motors
Moderator -
Posts: 12,488
Joined: March 08, 2002
Location: Manitoba, Canada
Posted: April 22, 2008 at 8:15 PM / IP Logged
Did you use the search function ? This vehicle has been on the forum tons since it came out.
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
eclipse_420
Member -
Posts: 4
Joined: April 22, 2008
Location: Michigan, United States
Posted: April 22, 2008 at 9:42 PM / IP Logged
| 12 Volts | RED / white (2A) | + | ignition harness |
| Second 12 Volts | RED / black (60A), RED / black (60A) | + | fuse box, black 40 pin plug, pins F1 and E3 |
| Starter | yellow/black (not for remote start) | + | ECM, black 73 pin plug, pin 52 |
| The ECM (Engine Control Module) is on the driver side fender, behind the headlight. |
| Second Starter | pink/black | +9.6K ohms | ignition harness or BCM, lt. green plug, pin 2 |
| Ignition | pink | + | ignition harness or BCM, lt. green plug, pin 14 |
| Accessory | brown or yellow | + | ignition harness or BCM, lt. green plug, pin 21 |
| Second Accessory | same as second starter wire | +6.3K ohms |
| Keysense | same as second starter wire |
| Data Bus | pink/black (resistor code), white (5V reference) | mux | ignition harness or BCM, lt. green plug, pins 2, 4 | | The BCM (Body Control Module) is to the left of the steering column. |
|
| Power Lock | use interface module |  | | | If interface module is not available. To lock/unlock the driver door go to the driver door module or motor in the door and 5 wire the tan (lock) and purple (unlock) motor wires. To lock/unlock the passenger door go to the passenger door module or motor in the door and 5 wire the tan (lock) and gray/black (unlock) motor wires. To lock/unlock the rear doors use lt. blue (+) and white (-) at the BCM, gray plug, pins 7 and 9. The BCM (Body Control Module) is to the left of the steering column. On the base model trucks, lock is pink/black (-) and unlock is ORANGE / black (-) at the BCM, gray plug. |
|
|
| The BCM (Body Control Module) is to the left of the steering column. |
|
| Meter this wire while turning the key in the driver door key cylinder. The DDM (Driver Door Module) is in the driver door. |
|
Follow the12volt.com
Saturday, May 4, 2024
• Copyright © 1999-2024 the12volt.com, All Rights Reserved
• Privacy Policy & Use of Cookies
Disclaimer:
*All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.
Topic Closed)
Members
Search
Register
Login
Printable version
