08 tacoma lock issue with viper 5000

My dad just bought a new 08 Tacoma access cab and has already had it broken into once, so I offered to let him have a viper 5000 i pulled out of my old car and had laying around. He said he wanted it so I sent it in under warranty to have an issue with a fried hoodpin circuit fixed and just got it back just as new. Wiring schematic for tacoma: https://www.the12volt.com/installbay/forum_posts.asp~TID~99263 Lock Harness: VIOLET* Unlock #87 Normally Open (Input) BLUE/BLACK Unlock #30 Common (Output) BROWN / BLACK Unlock #87a Normally Closed VIOLET/BLACK* Lock #87 Normally Open (Input) GREEN/ BLACK Lock #30 Common (Output) WHITE/ BLACK Lock #87a Normally Closed BLACK/ WHITE DomeLight Supervision relay Input #87 Issue: I have the violet/black grounded to vehicle, blue/black to vehicles GREEN/ black (unlock) and GREEN/ black to vehicles violet wire (lock). When activating alarm, or deact, the vehicle does not lock or unlock. No other wires were used in the harness. Testing: I have tested with a dmm to make sure the viper lock relays are working properly and both the blue and green wires ground when activated. I have tested the tacoma wires and found that the green black grounds when turning drivers key cylinder, but the violet does not (yet neither work with alarm). Also, according to a wiring schematic for the 08 tacoma that i obtained, I have the correct wiring. Any ideas or issues people can share?

I ran outside real quick (I have the truck pulled apart in my garage) and grounded that wire and now I can hear the relays click within the brain, but still no lock unlock action (already had programmed for double on unlock)