clifford 3.3x remote start on wk srt8

Started installation this morning. 1. Programmed XK532 bypass (both stages - transponder and the module itself) At XK module: Connected Red and Black to constant +12 and ground violet/white to violet/brown at ignition harness ( is it correct??) Pink - to pink/orange at ignition harness violet to pin 6 at SKIM module brown to Blue RS status at Remote start output harness at Clifford 2. Wired Clifford 3.3X using D2D cable to XK532 (dip switches horisontal) Wired RED, RED / White, RED / black at H3 harness and Red on H1 harness to constant 12 volt (battery). Green starter - to key side of cut starter wire (pink/orange at ignition harness) violet starter - to car side of cut starter wire (pink/orange at ignition harness) Pink Ignition 1 to Pink/light green wire at ignition harness) Orange (acessory) - don't know where to ???? Pink/White and Pink/Black - N/C Black at H1 harness - to ground (the same as for XK, and siren) Grounded neutral safety switch Brown (brake) to brake pedal harness (+12 when brake pressed) Wired siren red wire to brown (siren at H1 harness) Connected Neutral safety switch (On position) Leaved tach and Hood pin switch wires N/C 3. reprogrammed 3.3X to auto trans Alarm and wireless door lock work, Remote start - do not Can not run tach learn (led does not goes on constantly) Cannot figure where to hook orange (acessory) wire at H3 What else I'm missing?

The car is jeep WK 06 srt8