viper 5701 and 03 evolution

Ok so I have everything installed in the car and the alarm works fine. 

With the exception of the domelight supervision. 

But more importantly.  I need help with the ignition wires.

Here are my wires from the car.

Function           polarity                    Vehicle Wire

Constant             +                              white

Ignition                +                              blk/wht

Accessory           +                              blu/wht

Accessory 2        +                              blu/blk

Starter                  +                               blk/yel

so, so far this is my alarm connection

alarm                         vehicle

pink                             blk/wht

RED / wht                        not connected

orange                         blu/wht

violet                             blk/yel (S)

green                            blk/yel (k)

red                                 wht

pnk/wht                         blu/blk

pink/blk                         not connected

RED / blk                           not connected

....................................................................................

Im getting confused about the accessory 2 wire .. Im reading that according to my connection this has to be programmed as an accessory circuit?  If this is the case what other wires do I have to connect.  

So far with this connection.. you can initialize rs by hitting the brake pulling ebrake releasing brake and hittings rs open door and upon arming the car shuts off.  But when you try to restart the car wont go.  I dont need a bypass since i removed the immobilizer I am using a different ecu a stand alone engine management system.

Any help is appreciated