gas door

Home / the12volt's Install Bay / Car Security and Convenience / gas door (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

04nata

Copper - Posts: 358

Joined: April 22, 2008

Posted: August 22, 2008 at 2:34 PM / IP Logged

I have a Clifford Matrix RSX3.3 installed and I was wanting to wire the gas door to the alarm (since gas is gold these days) the car has a gas door switch on the inside that opens the door, so would I still have to put a pin switch in or is there some way I could wire it from the existing latch to trigger, so that if someone forces the gas door open it will set off the alarm.

Back to Top

megaman

Copper - Posts: 385

Joined: June 24, 2008

Location: Montana, United States

Posted: August 22, 2008 at 3:39 PM / IP Logged

You'll need to install a pin-switch as the wire currently in the vehicle only releases the gas door.

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

gas door

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.