valet switch not working module?

Home / the12volt's Install Bay / Car Security and Convenience / valet switch not working module? (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

vixentd

Member - Posts: 2

Joined: September 01, 2008

Location: British Columbia, Canada

Posted: September 01, 2008 at 5:12 PM / IP Logged

APS-15KB Presige auto security alarm in a motorhome. Was working fine but now

1. a slow flashing red light stays on when alarm is not activiated

2. When alarm is activiated the led flashes normall.

3. When alarm is turned on, one beep, when turned off 4 beeps from siren.

We have

1. Checked for ground at the module for valet switch and one side is ground.

2. Checked the valet switch itself to see if it was working, and it shows on an ohm meter that it is opeing and closing.

Any thing else besides the module that might be the problem?

gremechar

Member - Posts: 8

Joined: August 13, 2008

Location: Netherlands Antilles

Posted: September 01, 2008 at 10:05 PM / IP Logged

it's xlear that your 12v in the run position is ,issing

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

valet switch not working module?

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.