91 camry, door lock, viper 160xv

Home / the12volt's Install Bay / Car Security and Convenience / 91 camry, door lock, viper 160xv (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

itmero

Member - Posts: 2

Joined: October 30, 2008

Posted: October 31, 2008 at 4:38 PM / IP Logged

hi dudes and dudettes,

I am newbie here and asking for help in installing the door lock in my 1991 toyota camry V6. My unit is a viper 160XV and its remote starter and other functions are already working except for the lock/unlock features. this is what i know so far.

1) wires on the door lock harness - light blue and green

2) the lock wire on my car is light green

3) unlock wire on my car is dark green.

QUESTION:

1) how should i connect the four (4) given wires?

2) do i still need a relay to interconnect these wires?

3) what is techtips 1041? from the previous posts, i cannot access the directtechs 1041.pdf site.

please help me.

thank you very much for your time.

BSURSUCSIMIM

Raja Daremoj

Back to Top

i am an idiot

Platinum - Posts: 13,667

This member consistently provides reliable information

Joined: September 21, 2006

Location: Louisiana, United States

Posted: October 31, 2008 at 5:42 PM / IP Logged

According to the Audiovox site, the colors of the wires on the car are as follows. You should not need a relay to connect to these wires.

	Power Unlock		GREEN/ RED		(-)		DRIVERS KICK PANEL
	PowerLock		LIGHT GREEN		(-)		DRIVER'S KICK PANEL

Back to Top

itmero

Member - Posts: 2

Joined: October 30, 2008

Posted: October 31, 2008 at 6:26 PM / IP Logged

thanks bro but how do i connect the viper wires to these lock/unlock wires? cut these wires and connect the viper wires or interconnect these wires? thanks again

BSURSUCSIMIM

Raja Daremoj

Back to Top

i am an idiot

Platinum - Posts: 13,667

Joined: September 21, 2006

Location: Louisiana, United States

Posted: October 31, 2008 at 6:46 PM / IP Logged

You just need to connect the wire from the alarm to the wire of the car. Remove a small section of the insulation, twist the alarm wire around the exposed piece of wire, solder it and insulate it. Or cut it strip it, slide a piece of heat shrink tubing over the wires, Solder them and cover the joint with the heat shrink, shrink it.

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

91 camry, door lock, viper 160xv

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.