2005 buick terezza
Welcome Guest :)
jkyliej
Copper -
Posts: 101
Joined: September 28, 2004
Location: United States
Posted: December 22, 2008 at 4:58 PM / IP Logged
All,
Looking for the vehicle wiring for a 2005 Buick Terezza. I searched the forum but only found one post where someone had put up some wiring codes but it was a little vague. Hoping since then someone has done one and can post the wiring chart.
Thanks.
jkj
ceasar326
Copper -
Posts: 239
Joined: February 02, 2006
Location: Minnesota, United States
Posted: December 22, 2008 at 5:13 PM / IP Logged
| 2005 Buick Terraza | Last Update: 11/13/2008 | < name=print =wiresprint.asp>< = value=7863 name=recnum> < class=submit =submit value=PRINT name=printsubmit> | |
| Circuit | | Wire Color | | Location | |  |
| Constant 12 volts | RED or RED / BLACK AT | BCM C1 PIN 51, BATTERY OR FUSE BOX |
| Ignition 12 volts | PINK | AT BCM, C1, PIN 22 * |
| Starter | YELLOW | AT BCM, C1, PIN 21 * |
| Dome Light | GRAY/BLACK (-) | AT BCM, C1 PIN 43 * DOOR PINS ** |
| Trunk Pin | LIFT GATE (-) | AT BCM, C2 PIN 3 * |
| Parking Lamp | BROWN (+) FUSE BOX OR | PASS KICK HARNESS TO REAR (SEE TECH) |
| Lock | PINK/BLACK IN DRIVER | KICK OR AT BCM C2 PIN 2 * #201 |
| Unlock | ORANGE / BLACK IN DRIVER | KICK OR AT BCM C2 PIN 11 * |
| | #201- See Negative Pulse Door Lock Diagram. * See Tech On Location And Connectors. ** The Drivers Door Is A GRAY/BLACK (-) Pin 26, The Pass Door Is A TAN/WHITE (-) Pin 17, The Drivers Rear Door Is A L BLUE/BLACK (-) Pin 7 And The Pass Rear Door Is A L GREEN/ BLACK (-) Pin 5.Diode Isolation Is Required. | |
| Tach Signal | | ORANGE / WHITE | | IN LARGE HARNESS ABOVE ENGINE #239 | | |
| Ignition #2 | | |
| Ignition #3 | | |
| Accessory | BROWN | AT BCM C1 PIN 23 * ** |
| Neutral Safety | NA | |
| Brake Light | WHITE (+) | AT BCM C1 PIN 30 * |
| Reverse Light | L GREEN (+) | AT BCM C2 PIN 42 * |
| Rear Defrost | WHITE (-) | AT BCM C2 PIN 16 * |
| | #239 See Immoblizer Bypass System * See Tech On Location And Connectors. ** Additional Accessory Wire BROWN Is Required. If Not Powered You Will Get A Pass Lock Light and vehicle will not start. In Addition To This The GREEN Key Sense Wire Must See A Ground When Running. If Not The Service Required Light Will Come On. Its The Light With The Car And Wrench On It. | |
| Window Up | | - | | D\D BLUE P\D BLUE AT SWITCH IN #211 | |  |
| Window Down | - | D/BROWN P/BROWN DRIVERS DOOR |
| Keysense | LT GREEN (-) | AT BCM C1 PIN 40 * |
| Trunk Release | D GREEN (-) | AT BCM C2 PIN 3 * |
| OEM Horn | TAN (-) | AT BCM C1 PIN 4 * |
| Headlights | TAN/WHITE (-) | AT BCM C1 PIN 7 * |
| OEM Alarm Arm | | |
| OEM Alarm Disarm | PURPLE (-) | AT BCM C2 PIN 24 * |
| | #211- See Reversal Rest At Ground Power Window Circuit Diagram. * See Tech On Location And Connectors. OEM Hood Pin: PINK/BLACK (-) At BCM C1 Pin 26 Right Sliding Door: L BLUE (-) At Roof Console Left Sliding Door: L BLUE/BLACK (-) At Roof Console | |
| OEM Keyless Module | | - | | UNDER DRIVERS DASH BUILT INTO BCM | |  |
| Motor Lock | GRAY | AT BCM * CONN C2 PIN 52 |
| Motor All Unlock | TAN | AT BCM * CONN C2 PIN 51 |
| Motor Driver Unlock (disarm defeat) | TAN | AT BCM * CONN C2 PIN 48 |
| OEM Lock Relays | - | BUILT INTO B.C.M. |
| Add On Security Type | - | #5 CONNECTION #225 |
| | #225 See AL-100/VIP-4000 Type 5 Diagram * See Tech On Location And Connectors |
jkyliej
Copper -
Posts: 101
Joined: September 28, 2004
Location: United States
Posted: December 23, 2008 at 9:00 AM / IP Logged
Thank you, I appreciate it.
jkj
Follow the12volt.com
Saturday, April 27, 2024
• Copyright © 1999-2024 the12volt.com, All Rights Reserved
• Privacy Policy & Use of Cookies
Disclaimer:
*All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.
Topic Closed)
Members
Search
Register
Login
Printable version
