08 acura tsx

I tried to install starter/alarm in my sister 08 acura tsx but i'm stuck because i'm really confused about factory DisArm and rearm wire the diagram just show only disarm also it stated in side driver door(FACTORY ALARM DISARM   WHITE (-)   @ DRIVERS DOOR MODULE IN DRIVERS DOOR ) so my question is : Do i have to find wire inside the door and connect it there or it should be connect some where in side car under dash... I've tried to trace the white wire with silver dot it go inside car but show no contact I really need help to find this wire Many thanks

yes...to my knowledge that is the only place to get it...There are units you can buy to control door locks/factory security.M.E.C.P & First-Class

Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!

Hi tommy! What's part you are talking about? Do you have any sugestion how to run this wire from/to that port??? Thanks

XK01 - Programmable Platform# 01: Door Lock & Alarm Interface

Firmware: HODL4 2.00 M.E.C.P & First-Class

Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!

  CANMAX400 Multi Function Programmable Vehicle Interface

Firmware: 400.HONDA4 0.09  

Combination of Immobilizer Bypass and Data Bus Door Lock Control

M.E.C.P & First-Class

Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!

Try going into drivers door and you will find a white and red for your arm and a white for your disarm. Goodluck

You can use a data module to control the alarm features as well as bypass the OEM immobilizer. It's way easier and no need to run wires into the door. The door also has a molex which is a tremendous PITA for anyone to have to run wires through it.Jeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA

Ditto ...If it is your first adventure w/ molex...By-pass will work fine...Pretty easy install...

Velocity Motors wrote: You can use a data module to control the alarm features as well as bypass the OEM immobilizer. It's way easier and no need to run wires into the door. The door also has a molex which is a tremendous PITA for anyone to have to run wires through it.

M.E.C.P & First-Class

Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!

Thank You all for repplied after some research and sugestion I think I will go with Idatalink module which control door and immob. too Once again The12volt is the #1 place to get help