toad a101cl locking when disarmed

Hi, I have an A101CL installed. Tonight I have been changing a few settings. Firstly to stop the auto locking after about 20 seconds of the ignition being on, that worked fine. The other I was trying to change is the auto-rearm after a disarm. This appears to work in the sense that the alarm will not arm any more but it locks the doors only. So, if: I press button 1. This arms the alarm and locks the doors. Then, I press button one a bit later and it unlocks and disarms. Then, after a bit the indicator light will start rapidly flashing and then after maybe a minute the doors will lock, the indicator light is now OFF. However, if I open the door with the actual key and get in I can start the engine and the alarm won't go off. It seems disarmed. I can not find anything like this in the installation manual (bought from Abacus today). I would appreciate some help with this. Many thanks, Jack

PM me with your email address I'll send you the programming sheet from the install guide.

howie ll wrote: PM me with your email address I'll send you the programming sheet from the install guide.

PM sent. Thanks!