canmax400dei and viper 5501 in 2007 titan

I am looking to do a remote start and alarm system on my 2007 Nissan Titan SE. It has factory keyless entry.

My question is regarding using the Viper 5501 with the CANMAX400DEI.

Any installers do a 2007 Titan before and are the connections fairly easy to access if wiring the system hard wired?

Any experience with the CANMAX400DEI ? I know I have to get it flashed for the titan before using. Any other concerns or considerations?

Does the 5501 need to be programmed with a programmer or can everything I need to do be done via the switch and door open modes?

I know Im asking a butt load of question but Id prefer asking and hope to get some sound advice before embarking on this install.

Thanks for any replies and advice

yes you are correct, the can module will take care of most wires. you will only need to wire up ign, acc, start x2, brake, and a few other wires.

if you hardwire without a module, it requires abit more work, but not too bad.

never used the canmax, not a huge dei user, mostly compustar, ifatalink(blade) and fortin user.

some settings need a bitwriter, but for basic changes, you should be fine using the motes and valet button.