python 991 door locks

adding door locks to jeep wrangler with python 991 it will lock but wont unlock used the wireing diagram on the web site for a 5 wire and still wont work please help!!!

time to probe the output comming from the 991 and see if its dead or not.Ted

2nd Year Tier 1 Medical School

Still installing as a hobby...pays for groceries

Compustar Expert

Also have you verified you have the correct motor wire?commit your way to jehovah and he will act in your behalf. psalms 37:5

i did probe it and the lock side goes from 12v to 0v when i hit lock and it works but when i hit unlock and probe the unlock side it stays at 12v is there a seting on the 991 that needs to be changed??.....and yea i have the right motor wire

im sorry i ment when i hit lock the lock wire from the 991 says -500ma and when i hit un lock the unlock wire coming from the 991 doesnt change its like the 991 isnt sending the signal to the unlock relay???? could there be a setting on the 991 or somthing???

Not sure, what's a Python but snaking around, my thoughts are that baby has a two wire locking system, thus a 451 or a pair of relays needed. But wait....what year is this beast? Early models, 92-5 used pos triggers on the factory relays, hence 5 wire not required. Later variants used a resistive multiplex trigger. So can we have some testing please?

its a 2000 but it doesnt have factory door locks so im using dei's 524n lock actuators

Nope no setting could affect that! A simple test, momentarily ground the trigger of the relay where unlock wire is connected if the locks pop, then you have a defective unit!commit your way to jehovah and he will act in your behalf. psalms 37:5

Right Darren, you get the cigar this time, now go over to the Vehicle info section, look at Toyota Yaris/Fun cargo and see why my blood pressure's gone up the charts. The guy is in the Windies so maybe you can have a go.