5301v problems

Hi guys I am at a loss I am installing  a viper 5900/5301v into a 2003 mountaineer the accesories added to the system are 506t glass sensor and xk05 xpreesskit bypass pre programed by autopreservers .I also have relays set up for (gem wakeup , trunk release, factory disarm ,horn,and dome)

So heres whats happening when I apply power to the system the horn honks once other than thats all it does the blue led does not light up and the siren does not chirp the remote indicates that it is recieving signal via 3 vibrations but nothing actualy happens does not lock/unlock remote start or trunk pop. however i am able to start vehicle and operate lock/unlock trunk pop with factory remote.The light on the xk05 stays constant and wont program keys I tested valet button its working, I dont have a bitwriter yet so I cant scan.PLEASE HELP

wire connections made

harness 1

h-1-1 RED / wht to  trunk relay 

h-1-2  red to12v+

h1-3  brown to siren  red

h-1-4 empty

h-1-5  black to ground

h-1-6  violet to door trigger + blk/blu

h-1-7  blu --not connected

h-1-8  grn--not connected

h-1-9 blk/wht to dome relay out to  blk/blu

h-1-10  wht/blu-- not connected

h-1-11  wht to park lights + brown

h-1-12  orange not connected

harness 2

h-2-1  lt blu--not connected

h-2-2  wht/blk--not connected

h-2-3  violet/blk--not connected

h-2-4  grn/wht--not connected

h-2-5  grey/blk--not connected

h-2-6  lt grn/blk to factory disarm relay to GREEN/ violet

harness 3

h-3-1  blk/wht to nuetral safety wht/red

h-3-2  violet/wht to tach tan / YELLOW

h-3-3  brown to + brake brown

h-3-4  grey to hood pin switch

h-3-5  blu/wht not connected

harness 4

h-4-1 ORANGE / blk not connected

h-4-2  brown to horn relay to yellow/lt green

xk05

brown to blu ribbon status

violet rx to grey/orange

orange tx to wht/green

red to 12v +

blk to ground

506t

wired through provided harness through shock sensor

door lock harness

pin 1 lt blu to - unlock

pin 2  empty

pin 3 green to - lock

remote start ribbon harness plugged into xcrs 500m

pin 7 on ribbon cable blue (-) 200 mA STATUS OUTPUT is conected to brown wire on xk05 xpresskit

xcrs 500m

4 of the wires on the 500m were soldered in the wrong pinouts I researched this and found  to go by pin digram not color these were switched to correct locations

Sorry 2003 murcury mountianeer v8 factory alarm also arms/disarms

With just power and ground applied to the system, and the antenna plugged in ....... you should be able to get the system and LED to respond.   The horn should not honk when you power the system up.

Are you sure you have a good system ground, and power source?  Where is your system grounded?