is 2w9000fmr compatible to cm6000?

hey guys,

i install a cm6000 unit for my car and using a 2w9000fmr 2way remote, my problem is that i cant do the option program using the 2way remote. i dont see any flash if i press those option programming.

i can lock/unlock the car, i can start the car but the remote is not working for the option programming.

do you guys know whats wrong? is the cm6000 unit compatible to 2w9000fmr remote?

if i use the op500 device to program the unit, it will work or not?

thanks

The OP500 will work.  It's easy enought to find out, just disconnect the antenna wire from the antenna and plug it into the OP500.

There is anothe way to change /set options on the CM6x00.  If you have a Blade cartridge and the iDatalink ADS USB programming cable, try this:

Temporilary insert any Blade module into the CM6x00 blade slot and connect the ADS USB cable ( that is used to flash the iDatalink bypass modules ) into  CN6 Black RS232 port on the CM6000.  Then go to the iDatalink web site ( http://www.idatalink.com/helpdesk/ ) and click on "Flash your module".  While to primary purpose of this is to flash the blade module, after you select any blade firmware, the next screen allows you to update the Compustar CM6x00 if necessary and also set the programming options.

hi bro, need your help.

i bought a op500 unit from lesselectronics (ebay). i try to program the cm6000 unit but i only see option menu 1 and option menu 2 on the screen of op500. i cant see the option menu3 and menu4 . do you know whats wrong.

i need the menu3 to set my domelight into automatic but i cant see the menu3 and menu4.

what should i do now?

thanks

When you first plug the OP500 in, does it go thru its' self diags and show "0186 Success Good"?

Next display should be 1-01 on the top line and 1 on the bottom line.   ( Menu - Option  /  Selection )  Pressing the Right Arrow should step you thru all the options and menus available for the CMxx00 connected.  On the CM6200 Ver 3.11 I have connected right now, after 2-13 it  goes to 3-01. 

yeah, when i plug the op500 into the antenna cable it shows "0186 success good"  after that i can see the option 1-01 to option 2-13. after option 2-13 the display will go back to option 1-01. i dont see the option 3-01. if i try to set those 2 available option and press the W button, i keep getting a error code "Er02 fail"

do you think i need to update the firmware of the cm6000? how? i have the the ads usb cable, y cable and op500.

thanks

I doubt it's due to the firmware.  I do it the easy way mentioned above but If you don't have a Blade module....

Did you try the OP500 on another Compustar brain?  You can do it on the bench by connecting +12v to the two heavy gauge Red wires and ground to the Black wire from that same Compustar connector.  Then plug in the 4 pin antenna lead and OP500.