04 ford explorer remote start wire

I'm trying to install a C3-RS-915LCD remote start on my 04 explorer with factory alarm i can match some wires from the remote start to the explorer but some idk were they go or if they don't go at all, please let me know if i can forget about some wire and were the other ones go Ground output while running- is the ground for a bypass second starter output- N/A 2-step unlock/factory disarm/sensor by-pass - ? Instant start and turn off input - FOR TESTING THE REMOTE START dome light control output - NEED RELAY FOR THIS Horn output(programmable) - SO IF I WANT TO USE THE FACTORY HORN Channel 4 programmable output -NEED HELP IDK Neutral safety switch input -IDK Ground output when disarmed -IDK Tachometer signal input -TO TACH WIRE Channel 6 programmable output -IDK Accessory 2 control output -IDK Diesel wait to start input -N/A Ignition 3 control output -N/A Zone 3(-) negative dor pin trigger -IDK WHATS MY DOOR TYPE Channel 2(trunk) output -IDK Zone 2 negative hood/trunk trigger -TO HOOD PIN (+)brake switch shutdown input -TO BRAKE SWITCH Zone 3(+) positive dor pin trigger -IDK DOOR TYPE (-) negative hood pin safety shutdown -TO DOOR PIN Ground output when armed -TO RELAY Channel 5 programmable output -IDK were to mount the senser??? can use the factory led on this?

ok here we go

Channel 4 and 6 are for extras like sliding doors or automatic trunk open etc not need for ur install

neutral safety switch has to see a ground for the remote starter to work usually connected to a toogle switch

Ground output when disarmed wont be used

Accessory 2 is if ur car has 2 acc wires that have to be connected for the remote starter to work

Zone 3 negative door pin is for ur doors which i believe are negative so u will connect this wire

Channel 2 is if u have an automatic open truck that u push the botton and it opens

 Zone 3 is if ur doors use a positive

negative hood pin goes to the hood so if ur hood is open the car will not remote start

The sensor i usually mount under the dash on a solid part of the car

The factory led will work if u connect the factory arm and disarm wires to the alarm

Confidence is the key to any project!!

this is great it helps alot, got some more question hope you can help on the stage shock sensor it has zone 1 warn away input??? zone4 ground trigger??? ground- to ground 12+volts- can i put all my +12volts on the same wire? programmable output 2 steps unlock output??? thanks for the help

soberano22 wrote: this is great it helps alot, got some more question hope you can help on the stage shock sensor it has zone 1 warn away input??? zone4 ground trigger??? ground- to ground 12+volts- can i put all my +12volts on the same wire? programmable output 2 steps unlock output??? thanks for the help

ok i know what to do with the shock sensor but not the programmable output 2 steps unlock output 12+volts- can i put all my +12volts on the same wire?

i just responded to ur private message

Confidence is the key to any project!!