dodge ram 2008

Hello I am in the middle of installation on viper 5902 I'm looking for wiring diagram for 2008 dodge ram that will tell me where to find door triggers, thank you any help I will really appreciate Aja. Adam

1500, 2500, or 3500?   2 dr. or 4 dr?

it's 2008 dodge ram 4 door 1500 hemiAdam

This info from Bulldog Security:

THE LEFT FRONT DOOR IS PURPLE IN PIN 1. THE RIGHT FRONT DOOR IS PURPLE / WHITE IN PIN 4. THE LEFT REAR DOOR IS PURPLE / ORANGE OR PURPLE /GRAY IN PIN 2. THE Right REAR DOOR IS PURPLE / YELLOW OR TAN / YELLOW IN PIN 3. USE ALL

4 WIRES AND DIODE ISOLATE EACH WIRE FROM EACH OTHER AND THE INSTRUMENT CLUSTER.

This info from Audiovox:

 LF Latch    VIOLET  (-)                   IN HARNESS IN DRIVERS KICKPANEL  

 RF Latch    VIOLET/WHITE  (-)     IN HARNESS IN PASSENGER KICKPANEL    LR Latch    VIOLET/GRAY  (-)       IN HARNESS IN DRIVER KCIKPANEL    RR Latch   VIOLET / YELLOW  (-)  IN HARNESS IN PASSENGER KICKPANEL

Soldering is fun!

viper 5902 Dodge ram 08 4 door installation Hello I need some help, I got all wires done you can say, accept parking lights wire witch I run through 1120ohm resistor witch is giving me negative, do I need to use relay to switch the wire to positive, if I do what's the right way to wire the relay, if there is different easier way to go through?? thank you. Adam

This note from AudioVox : MUST ISOLATE FROM THE SWITCH WITH A RELAY DUE TO A REST RESISTANCE FORM THE SWITCH, USE A 1.1K OHM RESISTOR

Set your Viper Parking Light jumper to (+)

Use 30/40A SPDT relay

Viper H1/11 to Relay Pin 86

Relay Pin 85 to Chassis ground

Relay pin 87a to Light Switch side of cut WHITE/ Light Green wire

Relay Pin 87  thru 1.1 K Ohm resistor to chassis ground

Relay Pin 30 to car side of cut WHITE/ Light Green wire

Soldering is fun!

viper 5902, just finished installation. Thank you very much for all your help, does anyone of you know where I would be able to find defrost mirrors wire in 08 ram hemi 1500 4 door. Thanks again. Adam