need wire list for 2008 vw eos

could someone post a tech sheet for the 2008 VW Eos.

Thanks,

Here is info from Bulldog Security:

VOLKSWAGEN

    MODEL  YEAR(S)  EOS   2007 -2008   KEY  T-HARNESS  IMMOBILIZER   N/A    N/A    VW'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, See NOTE #1   PART           COLOR                LOCATION  12 VOLT CONSTANT   RED (+), 50 AMP    @ FUSE BOX, (PIN 38), NOTE #2   STARTER  RED / BLACK (+)   @ VESCM, (12-PIN PLUG(G), PIN 1, NOTE #3   STARTER 2  N/A    IGNITION 1  BLACK (+)  @ VESCM, (12-PIN PLUG(G), PIN 11, NOTE #3  IGNITION 2  N/A     IGNITION 3  N/A      ACCESSORY /HEATER BLOWER 1  N/A      ACCESSORY /HEATER BLOWER 2  N/A      KEYSENSE  N/A      PARKING LIGHTS ( - )  N/A      PARKING LIGHTS ( + )  GRAY / YELLOW (+)   @ HEADLIGHT SWITCH or VESCM, (16-PIN PLUG(E), PIN 1, NOTE #3   POWER LOCK  BROWN / GREEN (-), NOTE #4, See DIAGRAM   @ DDCM, (20-PIN PLUG), PIN 32, NOTE #5   POWER UNLOCK  Use LOCK wire, (-) thru a 250 Ohm Resistor to UNLOCK      DOOR TRIGGER  BROWN / YELLOW (-)   @ DDCM, (20-PIN PLUG), PIN 7, NOTE #5   DOMELIGHT SUPERVISION  RED / PURPLE (-)   @ VESCM, (12-PIN PLUG(B), PIN 11, NOTE #3   TRUNK RELEASE  PURPLE (-)   @ CSCCM, (8-PIN PLUG), PIN 6, NOTE #6   SLIDING POWER DOOR  N/A      HORN  BLACK/ WHITE (+)   @ VESCM, (16-PIN PLUG(J), PIN 6, NOTE #3   TACH  NOTE #7   @ Any FUEL-INJECTOR   WAIT TO START LIGHT  N/A      BRAKE  BLACK/ RED (+)   @ BRAKE PEDAL SWITCH or VESCM, (16-PIN PLUG(E), PIN 2, NOTE #3   FACTORY ALARM DISARM   NOTE #8   @ DDCM, (20-PIN PLUG), PIN 16, NOTE #5   ANTI-THEFT  VW'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, See NOTE #1   @ IGNITION SWITCH TUMBLER   EXTRA INFORMATION NOTE #1: VW'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, Part # 791 Bypass Module, for REMOTE STARTING ONLY! Part # DLPK-CANBUS MULTI for REMOTE STARTING and DOOR LOCKS (Resistors for DOOR LOCKS, NOT REQUIRED) NOTE #2: the FUSE BOX is located at the LEFT END of th DRIVERS DASH. NOTE #3: the VESCM, (Vehicle Electrical System Control Module) is the RELAY BOX, Under the DRIVERS DASH. NOTE #4: this vehicle uses a 1-WIRE DOOR LOCKING SYSTEM, that Requires Extra Parts for operation. See DIAGRAM. The use of Bypass Module DLPK-CANBUS MULTI will do the ANTI-THEFT and DOOR LOCKS without the use of relays and resistors. NOTE #5: the DDCM, (Drivers Door Control Module) is located in the DRIVERS DOOR. NOTE #6: the CSCCM, ( Comfort System Central Control Module) is located behind the GLOVE BOX. NOTE #7: when using the TACH wire, use any wire NOT with a RED STRIPE(2.0T Engine) or a RED / BLACK(3.2 Engine) both test (AC) NOTE #8: to DISARM FACTORY ALARM (if needed) Requires a (-) thru a 250 Ohm Resistor on the GREEN / WHITE (-) wire, requires resistor and relay. TEST this wire while turning the KEY in the DRIVERS DOOR. 

Audiovox has it also :  http://techservices.audiovox.com/Login.aspx    Sign up is free.

Soldering is fun!

thanks man