where did i go wrong, remote start

I have read though most of the pages here on Remote Start and still can not get mine to work. If anyone wants where i have made a mistake tell me i have a Diagram what Color of wire and place i connected it. If you Cannot See what i have wrote please post i will write it out if i must

RED / white- auxiliary trunk release= not used

Red- 12 V constant = yellow@ ignition harness

Brown-Siren = red wire on Siren

WHITE/ brown- Flex parking light relay 87A = not used

Violet- door trigger + = BLACK/ light blue@ Dash

Blue- trunk instant trigger = not used

Green- door trigger - = not used

BLACK/ White- domelight supervision = not used

WHITE/ blue- remote start/turbo timer = not used

White- parking light = PURPLE / white @ Dash

Orange- ground when armed = not used

Harness 2 = not used

Harness 3

Pink- Iginition 1 = light GREEN/ purple @ ignition harness

RED / white- don't know = not used

Orange- accessory = gray / YELLOW @ ignition harness

Violet- starter wire= (wire going to starter) RED / Blue @ ignition harness

Green- starter wire= (wire going to key) RED / Blue @ ignition harness

Red- 12 V constant (for ignition) = yellow @ ignition harness

Pink/white- flex relay= not used

Pink/Black- Flex relay= not used

RED / black- 12 v constant (for accessory and starter) = yellow  @ ignition harness

remote start Input

BLACK/ White- neutral safety = ground

Violet/white- tach = tan / YELLOW underhood firewall by passenger

Brown- brake = light green @ brake pedal

Gray- hood pin = installed, Hood closed

Better look at  Diagram

https://i1138.photobucket.com/albums/n535/joelee053/Truckwiring.jpg

Can Start with key but not with Remote start  After hiting button box clicks then nothing no starter no lights on dash nothing

After connect pink to ignition wire Dash would light up be no remote start ( Remote did not  work at all, maybe the Box thought the tuck was already on) With Pink connected Started truck with key, Couldnt Turn off truck with key remove fuse from H3 Red Wire truck went off

First of all, did you use a DMM to test and verify every wire prior to connecting the H3  Harness?

The Red, RED / White, and the RED / Black need to be connected to the Yellow.  It looks like you have a 2nd ignition that needs to be connected to the Pink/White of the H3 harness.   WWW.bulldogsecurity.com lists the 2nd ignition as BLACK/ Lt Green.  http://techservices.audiovox.com/ is another service for vehicle wiring.=  as well as www.the2volt.com  has a vehicle wiring section.   All of these have a bit of a difference for your vehicle on the wiring.

I'm guessing that this is a Viper 5701 remote starter???

So i need to Add RED / White to Yellow

and Pink/white to lt GREEN/ black  and retest system

Will this stop Dash Light from being on at all times?

Yes this is the Viper 5701

I didnt know the truck had a 2nd ignition

Reading Diagram

Pink/White and Pink/ Black Are Default to Ignition 2 so do i connect both to BLACK/ Lt Green

I went to so many Site just so happen the site that i printed did not mention 2nd ignition