2006 ram, python 1401, chall

Finally got all my equipment and am about ready to install. Just would like to verify some of the connections I am making. I am installing in D2D. Red H1/2 12V Constant ----- Positive Battery terminal Black H1/5 Chassis Ground ------ Ground point in vehicle WHITE/ Brown H1/4 Parking lights Isolation ----- Switch side of parking lights wire White H1/11 Parking light Output ------ vehicle side of wire with 1K ohm resistor Pink H3/1 Ignition 1 input output ----- Yellow CHALL ign 1 Do I need to hook up any other power on the H3? Different gauge of the two wires has me concerned. Violet H3/4 Starter (+) ------- Starter (+) in vehicle ignition WHITE/ black CHALL ----------- PURPLE / brown MUX wire in ignition Anything I am missing? CHALL is rev 2.01 and does not show using a relay to isolate the MUX line, however, the latest instructions on the website do? Thanks for the help. Phil

Also the latest version of CHALL install show using Ign 2 to the Ignition line on the vehicle. Do I need to hook up the Ign 1 and Ign 2 30A fused inputs on the H3?