clifford rs1.5 in 2003 silverado

Please bare with me as i have only installed 2 other rs and they wne well. This is the forst with a relay satellite so I am a bit confused. So here it goes I have most of the wiring figured out just need some help finishing up.

1 Do I have to wire up the nuetral safety switch as stated in manual (never had to do it on others)

2 which bypass should I use I have a GMSL2, 1700G1, S420(?) or it came with a bypass and resistors

3 this rs has more wires than I have dealt with before do I need to use all of them or can I simplify this by eliminating wires? It has

primary harness 12 pin I know I use this but what do I do with the armed output, is that for a alarm?

does the remote start activation go to the bypass

domelight supervision is htat needed?

now for the relay satellite

starter output to starter side where does this hook up to?

I wasn't done yet don't know what happened.

there are 3 high current inputs do I hook both up to the same 12v constant?

where does the output to the second ignition go? Is this the one you need to hook up to the second white wire at the ignition on the truck?

Do I need to use the aux harness (H2) the truck dosn't have a factory alarm and I won't be needing a 4th channel

Remote start harness Do I need to hook up the neutral safety switch input?

DO I need to use the remote start aux harness?

Thanks in advance. I have never, in my limited time, had so many ?'s about wiring.  Just seems to be way more wiring than needed compaired to the others I have installed.

On this vehicle the wires you NEED are as follows: